Retro-R Panel
Gauge
Net Girth
Yield (psi)
Weight Per Sq.
Finish
29 36" 80,000 64# Galvalume Plus®
29 36" 80,000 64# Signature® 200
Signature is a registered trademark of NCI Group, Inc. Galvalume Plus is a registered and protected trademark of BIEC International, Inc.
*The Galvalume Plus® coating is subject to variances in spangle from coil to coil which may result in noticeable shade variation in installed panels.The Galvalume Plus® coating is also subject to differential weathering after panel installation. Panels may appear to be different shades due to this weathering characteristic. If a consistent appearance is required, MBCI recommends that pre-painted panels be used in lieu of Galvalume Plus®. Shade variation in panels manufactured from Galvalume Plus® coated material do not diminish the structural integrity of the product. These shade variations should be anticipated and are not a cause for rejection.
Consult the STEEL DEPOT COMMERCIAL/INDUSTRIAL OR "PBR"/"PBU" TECHNICAL/ERECTION MANUAL for proper product application, design details and other product information.

NOTES:

  1. Maximum panel length is 40'-0".
  2. The ¹/4-14 x 7/8" type Long Life Lap Tek (Fastener #4) screws supplied by MBCI are the only approved fasteners for installation of the Retro-R® panel. Any deviation from this procedure will release Steel Depot from any liability.
  3. Existing panels to which the Retro-R® panels will be attached, must be 36" wide and have major ribs 1¹/4" deep.
  4. Edge of panel in contact with concrete sheeting notch will result in excessive edge creep. Panel corrosion due to contact with concrete or any masonry product is excluded from Panel Warranty.

IMPORTANT NOTICE TO INSTALLER/CUSTOMER: Material should be inspected carefully prior to installation for defects including
excessive oil canning. Installation of material constitutes acceptance.

See Commercial / Industrial Color Chart for available colors