FLAT SHEET & COILS

GAUGE		WIDTH	FINISH	WEIGHT PER LF
	26	42³⁄₄”	Signature® 300	2.64#
	26	42³⁄₄”	Signature® 200	2.64#
	26	42³⁄₄”	Galvalume Plus®*	2.64#
	26	42³⁄₄”	Galvanized	2.77#
	26	48³⁄₈”	Signature® 200	2.99#
	26	48³⁄₈”	Galvalume Plus®*	2.99#
	24	42³⁄₄”	Signature® 200	3.32#
	24	42³⁄₄”	Galvalume Plus®*	3.32#
	24	48³⁄₈”	Signature® 200	3.75#
	24	48³⁄₈”	Galvalume Plus®*	3.75#
	22	42³⁄₄”	Signature® 200	4.22#
	22	42³⁄₄”	Galvalume Plus®*	4.22#
	22	48³⁄₈”	Signature® 200	4.77#
	22	48³⁄₈”	Galvalume Plus®*	4.77#
Signature is a registered trademark of Metal Building Components, L.P. Galvalume Plus is a registered and protected trademark of BIEC International, Inc.
The Galvalume Plus® coating is subject to variances in spangle from coil to coil which may result in noticeable shade variation in installed panels.The Galvalume Plus® coating is also subject to differential weathering after panel installation. Panels may appear to be different shades due to this weathering characteristic. If a consistent appearance is required, MBCI recommends that pre-painted panels be used in lieu of Galvalume Plus®. Shade variation in panels manufactured from Galvalume Plus® coated material do not diminish the structural integrity of the product. These shade variations should be anticipated and are not a cause for rejection.
NOTES: The camber tolerance for coils is one inch in any 20 feet. Strippable film available for flat sheets (except for “Low Gloss Paint Finish Systems”) upon request for an additional charge. Slitting available upon request at an additional charge. Flat sheet lengths other than 10′-2″ are available upon request. Minimum length 5′-0″, maximum length 14′-0″. Flat sheet lengths over 14′-0″ require special skid. Please inquire. All material is Grade D for flat sheets, Grade D or E for coils.